[. . . ] Before using the dishwasher, read the user instructions! CW 494 Quick Reference Guide GB On button Off button Programme selection button Start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. Options Add regeneration salt Only add regeneration salt immediately before starting a wash programme. Programme chart Programmes Loading instructions Detergent 2) A - Consumption 3) Litres 5. 0 B - kWh Minutes 0. 02 10 Pre-Rinse Rapid Normal 1) Normal Intensive 1) 2) cold Crockery to be washed later. [. . . ] Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided Upper rack: Fold down glass holder (A): Depending on the position, for example small or long-stemmed glasses. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Rack height adjustment (also when loaded): Lower adjustment: Pull the two rack handles (C) outwards and lower the rack. Pull the two rack handles (C) upwards until the rack clicks into place (factory setting). Upper adjustment: The rack must be level on both sides. Lower rack: Plate holders (D). Cutlery basket (E) Sharp knives and forks that might cause injury must be placed in the cutlery basket with the handles positioned upwards. Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, tin, hand-decorated crockery (unglazed), silver cutlery. What to do if. . . If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working Cause • No water supply. • Open the tap. Remedy • Clean the water supply tap filter. Check the domestic circuit fuse. • Starting the selected programme. • The programme can be set to “0” to start. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry If crockery is not perfectly clean • Insufficient rinse aid. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Change water hardness setting, if necessary add salt *. • not removable • Insufficient water softening, calcium deposits. [. . . ] Before contacting our After-Sales Service, take note of the following: • The nature of the fault. • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. [. . . ]